Installation of the Cant adjustable Rightsight
The sight is sent out with the level set so when the gun is strait up the level should be very close to center. You should install the sight so the stem is on the same vertical plane as the rear sight. This being accomplished get into position with the gun and get comfortable.
Take note of where the level bubble is and how much the sight tube should be rotated. Loosen the two screws that hold the sight barrel to the stem and rotate to your approximate setting. Get back into position and check to see were the bubble is. Continue this until you are happy that the sight is where you need it to be.
When completed you will need to Loctite the two screws. Use red if you have it, blue should work also. Remove only one screw at a time to apply Loctite. When you tighten the screws don't get all King Kongish, they are 6-32 screws into brass. Good and snug is enough.
If you have any questions please don't hesitate to call.